|
|
| (115 intermediate revisions by 2 users not shown) |
| Line 1: |
Line 1: |
| [[Category: Development Team Research Pages]] | | [[Category: Development Team Research Pages]][[Category: Johann's Research Pages]] |
|
| |
|
| This is some of the stuff that I'm busy with:
| | migrated to wireless dev |
| | |
| == High Performance Node - WEP/WPA ==
| |
| One of the requirements of the High Performance Node is to have WEP or WPA enabled between the wireless links of the mesh nodes. WEP and WPA are both methods enable the encryption of data before it is send over the air. WEP (Wired equivalence privacy) is an older standard and it makes use of a WEP encryption engine while the newer WPA standard added the use of an AES encryption engine. WEP encryption has some security flaws embedded into the protocol and there are several tools available on the Internet that can crack WEP keys. These tools are more effective with the cracking of 64bit WEP keys than with 128bit keys and they require a large amount of captured data. Note that not all WEP keys can be cracked, but only weak keys and that in WPA these security flaws were addressed and fixed.
| |
| | |
| Wireless adapters on Unix Systems can operate in three different modes: Client, Hostap (Access Point) and Adhoc mode. Most of implementations of wireless (802.11) networks are based on a model where there is one Access Point with several wireless clients attached to to it.
| |
| | |
| AP / client pic
| |
| | |
| Wireless Mesh networks make use of the less tested Adhoc mode of 802.11.
| |
| | |
| Mesh network pic
| |
| | |
| Enabling WEP in Adhoc mode on FreeBSD.
| |
| WEP makes use of a single PSK that needs to be configured on all the wireless nodes. Any node or wireless device that is configured with this PSK will have the capability to crypt and decrypt these wireless packets. There are two methods to configure WEP in FreeBSD. You can use either use ifconfig directly or you can make use of the WPA supplicant utility.
| |
| | |
| ifconfig e.g.
| |
| | |
| == Voip - IP04 ==
| |
| | |
| | |
| == High performance node - Antenna selection ==
| |